Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Oil Cooler: Service and Repair
REMOVAL
1. Drain cooling system.
2. Disconnect cooler inlet and outlet hoses.
3. Remove oil filter.
4. Remove oil cooler connector.
INSTALLATION
Fig. 46
1. Lubricate seal and position oil cooler to fitting on cylinder block (Fig. 46).
NOTE: Position the flat side of oil cooler parallel to dipstick tube.
2. Install oil cooler connector and tighten to 27 Nm (20 ft. lbs.) (Fig. 46).
3. Install oil filter.
