Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Spark Plug: Service and Repair
Spark Plug #1 Replacement
REMOVAL
1. Remove the accessory drive belt.
2. Remove the 4 bolts from the upper half of the generator bracket.
3. Push the generator rearward.
4. rasp the spark plug boot/shield assembly as close as possible to the spark plug. Twist the boot/ shield assembly slightly to break its seal with the
plug and pull straight out. Do not use pliers, pull on the ignition cable, or pull the spark plug boot at an angle. This could damage the spark plug
insulator, terminal, or the insulation. Wipe spark plug insulator clean with a dry cloth before installation.
5. Remove spark plug
INSTALLATION
1. Install spark plug and tighten to 28 Nm (20 ft. lbs.).
2. When installing the spark plug cables, make sure the coil or spark plug insulator and terminals are fully seated. A click sound should be heard or
felt when the terminals are properly attached.
3. Pull generator back into place.
4. Install upper generator bracket with the 4 bolts.
5. Install the accessory drive belt.
