Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
7. Install a screw type hose clamp on the power steering fluid return hose to steel tube connection. Tighten the screw clamp to a torque of 2 Nm (18
inch lbs.).
CAUTION: The protective heat sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering fluid
pressure and return hoses.
8. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses
to keep them in their proper position.
9. Lower vehicle.
10. Refill the power steering system and perform Power Steering Pump Initial Operation Service Procedure. Refer to Power Steering Pump.
11. Check for leaks.
