Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Raise and support vehicle.
Crankshaft Position Sensor Connector
2. Disconnect Crankhaft Position Sensor electrical connector from the wiring harness connector.
3. Remove Crankhaft Position Sensor retaining bolt.
4. Pull Crankhaft Position Sensor straight up out of the transaxle housing.
INSTALLATION
Crankshaft Position Sensor and Spacer
NOTE: If the removed sensor is to be reinstalled, clean off the old spacer on the sensor face. A NEW SPACER must be attached to the sensor face
before installation. If the sensor is being replaced, confirm that the paper spacer is attached to the face of the new sensor.
1. Install sensor in transaxle and push sensor down until contact is made with the drive plate. While holding the sensor in this position, and install and
tighten the retaining bolt to 11.9 Nm (105 in. lbs.) torque.
2. Lower vehicle.
3. Connect Crankhaft Position Sensor electrical connector to the wiring harness connector.
