Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Ignition Cable: Service and Repair
Spark Plug Cable Service
WARNING: The ignition cables should not be removed while the engine is hot. This could cause sever injury/burns and can cause damage to
the ignition cables.
Spark Plug Boot/Heat Shield Orientation
The spark plug boot heat shield needs to be installed correctly on the boot before being installed on the engine. If it is not installed correctly engine
misfire would occur.
Do not use pliers to pull the boot/heat shield assembly from the spark plugs. This will damage the shield assembly.
Spark plug boot heat shields must be replaced if they are bent or damaged. It is extremely important the shield is reinstalled correctly as shown. The
bottom of the spark plug heat shield must make contact with the spark plug socket hex.
CAUTION: Never coat the inside of spark plug boots with silicone grease. Some types of silicone grease can damage the ignition cable conductor.
