Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Knock Sensor: Service and Repair
Knock Sensor
The knock sensor threads into the side of the cylinder block in front of the starter.
REMOVAL
1. Disconnect electrical connector from knock sensor.
2. Use a crow foot socket to remove the knock sensor.
INSTALLATION
1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly
causing improper spark control.
2. Attach electrical connector to knock sensor.