Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Ignition Cable: Description and Operation
The spark plug cables and spark plug boots are made from high temperature silicone materials. The spark plug boots utilize metal heat shields for
thermal protection from the exhaust manifold. The heat shields slide over the spark plug boots. The notches on the heat shields ensure the spark plug
boot and shield twist together during spark plug boot removal. They also identify proper heat shield installation on the boot for service. Refer to Spark
Plug Cable removal and installation. All spark plug cable leads are properly identified with cylinder numbers. The inside of the spark plug boot is coated
with a special high temperature silicone grease for greater sealing and to minimize boot bonding to the spark plug insulator. The convoluted tubing on
the rear plug cables are made of a high temperature plastic material. Under normal driving conditions, the spark plug cables have a recommended service
life of a 100,000 miles. The spark plugs have a recommended service life of 75,000 miles for severe driving conditions per schedule B in this manual.
The spark plug heat shield can be reused if an ignition cable is replaced due to failure. Never reuse heat shield's that have heat shield anti-twist, side or
spark plug attachment tabs bent or missing. Ensure that the heat shield is properly attached to the spark plug to avoid RFI problems. The bottom of the
spark plug heat shield must make contact with the spark plug hex.
The front ignition cables must not make contact with the oil dip stick tube and #5 cable must not touch the coil mounting bolt to avoid abrasion/dielectric
failures.
