Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
3. Assemble for installation of the front bushing, the Bushing Receiver, Special Tool 6908-5, Bushing Installer, Special Tool 6908, Nut, Special Tool
6908-3 thrust washer, threaded rod and small nut, as shown in on the lower control arm and front bushing.
4. To install the front bushing in lower control arm, hold the threaded rod stationary and tighten the Nut, Special Tool 6908-3. This will pull the front
bushing into the lower control arm.
5. Continue pulling the bushing into the lower control arm until bushing is seated squarely against the lower control arm and there is no gap between
the bushing and the lower control arm.
6. Install the lower control arm on the front suspension cradle.
