Town & Country Van V6-201 3.3L VIN R SMFI (1990)
Cruise Control Servo Cable: Service and Repair
Fig. 6 Speed Control Cable Adjustment
1. Remove air cleaner assembly.
2. On carbureted models, disconnect cable from carburetor stud by removing spring clip.
3. Disconnect cable from throttle body by removing retaining clip.
4. Disconnect cable from servo, then remove cable assembly.
5. Locate cable through servo mounting bracket.
6. Connect cable sleeve to servo stud, align holes, then install clip.
7. Insert servo studs through holes in cable and holes in bracket, then install nut-washers.
8. Route cable from servo, through cable support bracket and clip, then install cable end on stud of throttle body.
9. On carbureted models, adjust control cable as follows:
a. Start engine and let run, until normal operating temperature is reached.
b. Remove retaining clip.
c. Adjust clip until 1/16 inch clearance is achieved between throttle stud and cable clevis.
10.
Replace air cleaner.
