Town & Country Van V6-201 3.3L VIN R SMFI (1990)
Figure 2
This procedure involves installing an A/C compressor strut bracket.
1.
Remove cylinder head bolt that holds the ignition wire retaining bracket in place and discard bolt (Figure 2).
2.
Install stud, PN 6501589, into cylinder head where bracket retaining bolt was removed, and torque stud to 30-50 ft.lbs.
3.
Remove nut attaching A/C compressor closest to clutch assembly, and install the A/C compressor to cylinder head bracket PN 4612008 over both
studs (Figure 2). Install nut and washer PN 6101445 onto stud installed into cylinder head and torque to 200-300 inch lbs. Install nut removed
from compressor mounting bracket and torque to 30-50 ft.lbs.
Repair Procedure "AC", "AY", & "As" Bodies
This procedure involves installing a damper weight on the A/C suction line.
Remove sharp edges, clean, and paint weight assembly PN 4384991, before attaching to A/C hose. Use a good rust prohibitive black paint.
FIGURE 3
"AS" Body Vehicles
Install damper weight assembly PN 4384991, centered on A/C suction line hose as shown in Figure 3.
