Town & Country Van V6-201 3.3L VIN R SMFI (1990)
FIGURE 4
"AC" & "AY" Vehicles
Install damper weight assembly PN 4384991, one inch (1") from end as shown in Figure 4.
Tips, Capacities & Labor Allowance
If noise condition still exists after completing the above procedure, it will be necessary to verify the system is not overcharged. Connect a manifold
gauge set and refer to the A/C refrigerant system diagnosis chart with variable displacement compressor in the service manual for maximum pressures.
NOTE:
SOME POINTS TO REMEMBER:
When checking the system operation or recharging the system, it is important to understand that the noise is directly proportional to head pressure, the
higher the head pressure, the higher the noise.
Any overcharge condition will increase the head pressure and in turn cause more noise.
If system is overcharged, it will be necessary to evacuate the system into an approved recycling device.
The total system charge capacity includes between 10 and 14 ounces of refrigerant which is stored in the receiver drier as a reserve. Reducing the reserve
amount will not adversely affect the system performance.
When Charging the System Follow the Revised Capacity Listed Below:
Models
Revised Capacity
"AS" Body
Front A/C only
27 ounces
with rear A/C
38 ounces
"AC" & "AY"
31 ounces
Bodies
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
24-10-06-90
(Install Damper Weight. Includes
Installation of Strut Bracket if
Required)
. . . . . . . . . . . . . . . .
0.3 Hrs.
24-10-06-91 (Modify Compressor Bracket if Required)
AC, AY . . . . . . . . . . . . .
0.5 Hrs.