Town & Country Van V6-201 3.3L VIN R SMFI (1990)
Wheel Bearing: Service and Repair
Front
Pressed-In
Removal
1. Remove cotter pin, nut lock and spring washer.
2. Loosen hub nut while vehicle is on the floor and brakes applied. The hub and driveshaft are splined together through the knuckle (bearing) and
retained by the hub nut.
3. Raise the vehicle.
4. Remove wheel and tire assembly.
5. Remove hub nut.
CAUTION: Insure that splined driveshaft is "free" to separate from spline in hub during knuckle removal from vehicle. A pulling force on the shaft
can separate the inner joint. Tap lightly with soft brass punch if required.
