Town & Country Van V6-201 3.3L VIN R SMFI (1990)
Figure 7
^
Reinstall the clip to support the valve and hose assembly as shown in figure 7.
Figure 8
FOR AS BODY
INSTALLATION OF THE VALVE IS THE SAME AS THE AC/AY BODIES EXCEPT AS FOLLOWS:
DRILLING OF A HOLE IS NOT REQUIRED.
^
Cut the cooler hoses in line with with the center of the large hole in the bottom of the frame, figure 8.
^
Install bracket PN 4333568 to retain the upper cooler hose, using the existing lower battery tray attaching bolt as shown in figure 8.
NOTE:
SINCE THE VALVE ASSEMBLY WILL BE CLEAR OF THE FRAME RAIL WITH THIS INSTALLATION, THE
ANTI-RATTLE FOAM TAPE AND TIE STRAP ARE NOT REQUIRED.
^
Install the valve assembly and tighten the clamps.
^
Position the valve and hose assembly in the clip as shown in figure 8.
6.
Check and adjust transmission oil level as necessary.
POLICY:
Reimbursable within the provisions of the warranty.
