Town & Country Van V6-229 3.8L VIN L MFI (1995)
1. Pass seat belt through slot in D-pillar trim panel on short wheel base vehicle.
2. Position D-pillar trim panel on vehicle.
3. Engage speaker wire connector to speaker, if equipped.
4. Align locating pins on backside of trim panel to mating holes in inner quarter panel.
5. Engage hidden clips to hold trim to D-pillar.
6. Install screws to hold trim to D-pillar.
7. Install jack storage cover.
8. Install bolt to hold second rear seat belt lower anchor to quarter on short wheel base vehicle.
9. Install second rear seat belt turning loop on long wheel base vehicle.
10. Install liftgate sill plate.
11. Install rear header trim cover.
Left D-Pillar Trim Panel-Four Door
Right Quarter Trim Panel - Left On 4 Door
REMOVAL
1. Remove rear header trim cover.
2. Remove liftgate sill plate.
3. Remove second rear seat belt turning loop.
4. Remove bolt holding second rear seat retractor to quarter, if equipped on short wheel base vehicle.
5. Remove jack storage cover.
6. Remove screws holding trim to D-pillar.
7. Disengage hidden clips holding trim to D-pillar.
8. Separate D-pillar trim from vehicle.
INSTALLATION
1. Place D-pillar trim in position on vehicle.
