Town & Country Van V6-229 3.8L VIN L MFI (1995)
Brake Drum: Service and Repair
Brake Drum Removal
For additional information see Notes, Warnings, and Hints.
Fig. 9 Release Brake Adjuster
Fig. 6 Release type brake adjuster
1. Remove the tire and wheel assembly.
2. Remove rear plug from brake adjusting access hole.
3. Insert a thin screwdriver into brake adjusting hole and hold adjusting lever away from notches of adjusting screw.
4. Insert Tool C-3784 or equivalent, into brake adjusting hole and engage notches of brake adjusting screw. Release brake by prying down with
adjusting tool.
NOTE: The rear hubs are held on by the axle nut which should be covered by a dust cap.
Fig. 3 Wheel bearing assembly
5. Remove rear hub and drum assembly.
6. Inspect brake lining for wear, shoe alignment, or contamination from grease or brake fluid. Inspect wheel bearings for rust or signs of wear.