Town & Country Van V6-229 3.8L VIN L MFI (1995)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Modulator Assembly Replacement
1. Raise and support vehicle, then disconnect battery cables at battery.
2. Remove battery hold-down and battery from battery tray, then remove battery tray and Controller Anti-Lock Brake (CAB) from tray support
bracket.
3. Loosen battery tray support bracket to modulator assembly mounting bracket bolt, then the battery tray support bracket to frame rail bolt.
4. Lift battery tray support bracket out of vehicle, then remove battery acid shield from ABS modulator assembly.
5. Disconnect six brake tube fittings at modulator assembly, thread savers and proportioning valves, then remove brake tube bundle from modulator
assembly. It is not necessary to loosen fittings at junction block.
6. Raise and support vehicle, then disconnect wiring harness 10-way connector at modulator assembly.
7. Remove bolt securing speed control servo to modulator bracket, then position servo aside.
8. Loosen two bolts securing front of modulator bracket to frame rail, then loosen two rear modulator bracket bolts.
9. Lower vehicle, then remove modulator assembly and bracket from vehicle.
10. If necessary, separate modulator assembly from mounting bracket.
11. Reverse procedure to install. Bleed base and anti-lock brake systems separately.
