Town & Country Van V6-229 3.8L VIN L MFI (1995)
To adjust toe-in, center steering wheel and hold in position with a suitable tool. Loosen tie rod locknuts and rotate rod to adjust toe-in to
specifications. Use care not to twist steering gear rubber boots. Torque tie rod locknuts to 55 ft. lbs. Adjust position of steering gear rubber boots.
Remove steering wheel holding tool.
Preliminary Inspection
1. Tires are at recommended pressure, are of equal size and have approximately the same wear pattern
2. Check front wheel and tire assembly for radial runout and inspect lower ball joints and steering linkage for looseness.
3. Check front and rear springs for sagging or damage.
4. Front suspension inspections should be performed on a level floor or alignment rack with fuel tank at capacity, and vehicle free of luggage and
passenger compartment load.
5. Prior to each alignment reading, vehicle should be bounced an equal number of times from center of the bumper alternating first from rear, then
front, and releasing at bottom of down cycle.
