Town & Country Van V6-229 3.8L VIN L MFI (1995)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Throttle Body View With Idle Air Control Motor
Removal
1. Disconnect the negative battery cable.
2. Disconnect motor wiring connector.
3. Remove motor mounting screws (2-25 mm long, Torx head screws), and remove motor, (make sure the O-ring is removed from throttle body).
Idle Air Control (IAC) Motor Installation
Installation
NOTE: If the pintle measures more than 1 in (25 mm), it must be retracted using scan tool [1].
1. Install motor using a new O-ring, and torque mounting screws to 20 in-lbs (2 Nm).
2. Connect motor wiring connector.
3. Install air cleaner assembly.
4. Connect negative battery cable.
Remarks
