Town & Country Van V6-229 3.8L VIN L MFI (1995)
5.
Remove the plugs at the ends of the assist handle and remove the handle attaching screws (Figure 3).
6.
Remove the two (2) plugs at the lower corners of the trim panel and remove the lower trim panel screws (Figure 3).
7.
Remove the two (2) trim panel screws located in the speaker grille openings (Figure 3).
8.
Remove the two (2) plugs near the speaker grille openings in the center of the trim panel and remove the screws (Figure 3).
9.
Remove the six (6) trim panel screws along the top edge and upper sides of the trim panel (Figure 3).
10.
Disengage the frog leg clips around the perimeter of the trim panel and remove the trim panel from the liftgate.
11.
Disconnect the wiper motor electrical connector (Figure 4).
12.
Remove the five (5) wiper motor bracket mounting screws (Figure 4). Remove the wiper motor and bracket assembly from the liftgate and set it
aside.
13.
Install the remanufactured or new rear wiper motor and bracket assembly into the liftgate. Torque the five (5) attaching screws to 35 in-lbs (4 Nm).
14.
Connect the wiper motor electrical connector.
15.
Position the liftgate trim panel on the liftgate and engage the frog-leg clips around the perimeter of the panel.
16.
Install the six (6) screws along the top and upper sides of the trim panel (Figure 3).
CAUTION:
DO NOT over tighten screws as this could damage the trim panel or strip the screws.
17.
Install the two (2) screws located in the speaker grille openings (Figure 3).
18.
Install the two (2) screws and plugs in the center of the trim panel (Figure 3).
19.
Install the two (2) screws and plugs in the lower trim panel comers (Figure 3).
20.
Install the assist handle with the two (2) screws (Figure 3). Install the handle screw plugs.
21.
Connect the courtesy lamp electrical connectors and install the speaker grille/courtesy lamp assemblies.
22.
Close the liftgate.
23.
Install the liftgate wiper arm assembly.
