Town & Country Van 2WD V6-201 3.3L VIN R MFI (1996)
Seat Belt Height Adjuster: Service and Repair
Fig.14 Shoulder Belt Height Adjuster Knob
SHOULDER BELT HEIGHT ADJUSTER KNOB
Removal
1. Disengage clips holding clam shell cover to seat belt turning loop and open cover.
2. Using a Snap-On (r) trim tool, pry knob from shoulder belt height adjuster.
Installation
1. Place shoulder belt height adjuster knob in position on height adjuster.
2. Push knob on until retainers engage.
Shoulder Belt Height Adjuster
SHOULDER BELT HEIGHT ADJUSTER-B OR C-PILLAR
Removal
1. Remove B or C-pillar trim cover.
2. Remove screws holding shoulder belt height adjuster to pillar.
3. Separate height adjuster from vehicle.
Installation
Reverse the preceding operation. Tighten seat belt anchor bolts to 39 Nm (29 ft. lbs.).
