Town & Country Van 2WD V6-201 3.3L VIN R MFI (1996)
Seat Belt
SEAT BELT FIRST REAR OUTBOARD - 4 DOOR
Removal
1. Remove first and second rear seats.
2. Remove shoulder harness height adjuster knob by pulling it straight away from adjuster.
3. Slide floor anchor cover from over the anchor bolt.
4. Remove floor anchor bolt.
5. Separate anchor from floor.
6. Open clam shell cover from over seat belt turning loop.
7. Remove bolt holding turning loop to shoulder belt height adjuster.
8. Separate turning loop from C-pillar.
9. Remove lower quarter trim panel.
10. Route seat belt webbing and turning loop through access hole in lower quarter trim panel.
11. Remove bolt holding seat belt retractor to quarter panel.
12. Lift retractor upward and disengage arrow head retainer holding retractor to quarter panel.
13. Separate seat belt from vehicle.
Installation
Reverse the preceding operation. Tighten seat belt anchor bolts to 39 Nm (29 ft. lbs.).
Seat Belts
