Town & Country Van 2WD V6-230 3.8L VIN L SMFI (1997)
Park Brake Cable Removal From Body Bracket
6. To remove parking brake cable housing from the body bracket, slide a 14 mm box end wrench over retainer end compressing the three fingers.
Alternate method is to use an aircraft type hose clamp.
7. Remove the brake shoes from the brake support plate.
8. Disconnect parking brake cable from parking brake actuator lever.
Removing Park Brake Cable From Brake Support Plate
9. Remove the parking brake cable housing retainer from the brake support plate using a 14mm wrench to compress the retaining fingers.
INSTALLATION
1. Install the parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable housing
retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the parking brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body outrigger bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect rear parking brake cable to the equalizer bracket.
6. Install brake drum, and wheel and tire assembly.
7. Remove the locking pliers from the front parking brake cable. This will automatically adjust the parking brake cables.
8. Apply and release parking brake pedal 1 time, this will seat the parking brake cables.
