Town & Country Van 2WD V6-230 3.8L VIN L SMFI (1997)
Electrical Connection To Fluid Level Sensor
11. Remove vehicle wiring harness connector, from the brake fluid level sensor, in master cylinder fluid reservoir.
12. Clean the area where the master cylinder assembly attaches to the power brake booster. Use only a solvent such as Mopar Brake Parts Cleaner or
an equivalent.
Master Cylinder Attachment To Power Brake Vacuum Booster
13. Remove clip attaching drain hose to brake tube at master cylinder. Remove drain hose from wiper module. Remove the 2 nuts attaching the master
cylinder assembly to the power brake vacuum booster.
NOTE: It is not necessary to remove the brake tubes from the master cylinder when removing the master cylinder from the power brake vacuum
booster.
14. Remove the master cylinder and the brake tubes as an assembly from power brake vacuum booster. When master cylinder is removed, lay it out of
the way on top of the left motor mount
