Town & Country Van 2WD V6-230 3.8L VIN L SMFI (1997)
Vacuum Seal Installed On Master Cylinder
8. Install a NEW vacuum seal on mounting flange of master cylinder assembly.
9. Position master cylinder on studs of power brake booster, aligning push rod on power brake vacuum booster with master cylinder push rod.
Master Cylinder Attachment To Power Brake Vacuum Booster
10. Install the 2 master cylinder to power brake unit mounting nuts. Tighten both mounting nuts to a torque of 25 Nm (18 ft. lbs.).
11. Install the wiper module drain hose on the wiper module. Install the tie strap attaching the wiper module drain hose to brake tube at the master
cylinder. Tie strap should be loosely tightened so as not to collapse the wiper module drain hose.
Electrical Connection To Fluid Level Sensor
12. Install the wiring harness connector on the brake fluid level sensor in the master cylinder fluid reservoir.
Throttle Body Attachment To Intake Manifold 3.3L And 3.8L
13. Install the throttle body and throttle cable bracket on the intake manifold. Install the 2 bolts attaching the throttle body to the intake manifold and
