Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
20.
Using a suitable tool such as a 14 mm box end wrench compress the flared legs on the park brake cable retainer. Then pull the park brake cable out
of the support plate (Fig. 5)
21.
Disconnect the brake tube from the wheel cylinder.
22.
Remove the two bolts attaching the wheel cylinder to the brake support plate and separate the wheel cylinder from the vehicle.
23.
Remove the 4 bolts attaching the hub/bearing assembly to the flange of the rear axle.
CAUTION:
CORROSION MAY OCCUR BETWEEN THE HUB/BEARING AND THE AXLE MAKING IT DIFFICULT TO REMOVE. IF THE
HUB/BEARING WILL NOT COME OUT OF THE AXLE BY PULLING ON IT BY HAND DO NOT HIT/POUND THE HUB/BEARING.
POUNDING ON THE HUB/BEARING WILL CAUSE DAMAGE TO THE BEARING THAT RESULTS IN NOISE OR BEARING FAILURE.
