Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Brake Master Cylinder: Service and Repair
Master Cylinder Reservoir Replacement
1. Clean master cylinder housing and brake fluid reservoir. Use only a solvent such as Mopar Brake Parts Cleaner or an equivalent.
2. Remove the filler tube and brake fluid reservoir cap. Using a syringe or equivalent type tool empty as much brake fluid as possible from the
reservoir.
CAUTION: When removing fluid reservoir from the master cylinder, do not pry off using any type of tool. This can damage the fluid reservoir or
master cylinder housing.
3. Remove the master cylinder assembly from the power brake vacuum booster.
Master Cylinder Mounted In Vise
4. Mount the master cylinder in a vise using the master cylinder mounting flange.
Fluid Reservoir Retaining Pins
5. Using correct size pin punch, remove the 2 retaining pins between the fluid reservoir and master cylinder housing. Rock the brake fluid reservoir
from side to side while pulling up to remove it from the seal grommets in master cylinder housing.