Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
EGR Valve Attachment To Intake Manifold
6. Install EGR Valve and vacuum transducer on the intake manifold. Install and tighten the 2 EGR valve mounting bolts to a torque of 22 Nm (200
inch lbs.).
CAUTION: The master cylinder is used to create the seal for holding vacuum in the vacuum booster. The vacuum seal on the master cylinder
MUST be replaced with a NEW seal whenever the master cylinder is removed from the vacuum booster.
CAUTION: When removing the vacuum seal from the master cylinder do not use a sharp tool.
7. Using a soft tool such as a trim stick, remove the vacuum seal from the master cylinder mounting flange.
Vacuum Seal Installed On Master Cylinder
8. Install a NEW vacuum seal on mounting flange of the master cylinder.
9. Position master cylinder on studs of vacuum booster, aligning push rod on vacuum booster with master cylinder piston.
