chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Body Control Module|Testing and Inspection > < Airbag System|Page 2894
Page 18
background image

Bus (-) Open - The bus (-) wire has lost connection with termination and/or bias.

Not receiving Bus Messages Correctly - The DRB cannot communicate over the bus and does not know why.

Wiper System

FRONT

The front wiper system provide the driver with normal wipe (low and high speeds), intermittent wipe, wipe after wash, and pulse wipe functions.
The driver selects the wiper function via a resistive multiplexed stalk switch mounted on the steering column. When the wiper is in the on position
and the ignition is turned off, the wiper will continue to run until it reaches its park position.

Other front wiper system features:

Speed Sensitive Intermittent Wipe Mode - There are 6 individual delay times with a minimum delay of 1/2 second to a maximum of 18 seconds.
When the vehicle speed is under 10 MPH, the delay time is doubled to provide a range time of from 1 second to 36 seconds.

Pulse Wipe - When the wiper is in the off position and the driver presses the wash button for more than 62 msec but less than 1/2 second, 1 wipe
cycle in low speed mode will be provided.

Wipe After Wash Mode - When the driver presses the wash button for over 1/2 second and then releases it, the wiper will continue to run for 2
additional wipe cycles.

REAR

The rear wiper system provides the driver with continuous, intermittent, and wiper after wash functions. The driver selects the wiper function via a
resistive multiplexed switch mounted in the HVAC control.

Body Control Module|Testing and Inspection > < Airbag System|Page 2894