Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
6.
Seat the seal halves around the joint and then while holding the two seals halves together, install one of the provided clamps around the seal halves
(Figure 4).
7.
Tighten the clamp to 75 in-lbs (8.5 N.m).
8.
Install the remaining two seal halves around the rear fuel rail crossover tube joint (Figure 3).
9.
Seat the seal halves around the joint and then while holding the two seals halves together, install the other clamp around the seal halves (Figure 4).
10.
Tighten the clamp to 75 in-lbs (8.5 N.m).
11.
If the engine was equipped with an intake manifold cover (1996 and early-1997 3.8L only), the cover must be modified as follows:
a.
Remove the spring clip from the cover that was attached to the fuel rail near the crossover tube joint (Figure 5). Discard the clip.
b.
Using a small cut-off wheel, saw or similar tool, remove the plastic cover material inside of the mold line on the end of the cover (Figure 5).
