Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
2.
Using the provided Scotch-Brite pad, clean any dirt or white oxide build-up from the fuel rail area near the crossover tube joints (Figure 2). Clean
both of the crossover tube joints with the Scotch-Brite pad and then use compressed air to remove any remaining particles.
3.
Install the two provided clamps around the crossover tube. Start the clamps for 1-2 turns to ease seal installation.
4.
Lightly lubricate the rubber material of the four fuel rail seal halves with clean engine oil. Be sure to coat the flat ends as well as the two beads.
IMPORTANT:
Drain any excess oil from the seals.
5.
Install two of the seal halves around the front fuel rail crossover tube joint (Figure 3).
NOTE:
Both of the seal halves are identical.
