Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
3. Rotate sensor away from block (Fig. 7).
4. Pull sensor up out of the chain case cover.
-
Do not pull on the sensor lead.
-
There is an 0-ring on the sensor case. The 0-ring may make removal difficult.
-
A light tap to top of sensor prior to removal may reduce force needed for removal.
Fig 8 Camshaft Position Sensor And Spacer
NOTE: If the removed sensor is reinstalled, clean off the old spacer on the sensor face. A NEW SPACER must be attached to the face before
installation. Inspect 0-ring for damage, replace if necessary. If the sensor is being replaced, confirm that the paper spacer is attached to the face and 0-
ring is positioned in groove of the new sensor (Fig. 8).
INSTALLATION
1. Apply a couple drops of clean engine oil to the 0-ring prior to installation.
2. Install sensor in the chain case cover and rotate into position.
3. Push sensor down until contact is made with the camshaft gear.
-
While holding the sensor in this position, install and tighten the retaining bolt 14 Nm (125 in lb) torque.
4. Connect camshaft position sensor electrical connector to harness connector.
