Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Clockspring Locking Tabs
9. Remove clockspring from the housing assembly by depressing the 2 tabs on the clockspring.
10. Remove screws holding speed control switches to airbag cover and remove, if equipped.
INSTALLATION
For installation, reverse the above procedures. Do not connect battery negative cable.
UNDEPLOYED MODULE
REMOVAL
1. Disconnect battery negative cable. Allow at least two minutes for the reserve capacitor in the Airbag Control Module (ACM) to discharge.
2. Remove screws attaching airbag/horn switch to steering wheel.
3. Remove Driver Airbag Module from steering wheel.
4. Disconnect wire connectors from airbag module, horn switch, and speed control switches, if equipped.
5. Remove screws holding vehicle speed control switches to airbag cover and remove.
INSTALLATION
For installation, reverse the above procedures and do not connect battery negative cable. Do not connect battery negative cable.
