Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Fig. 9
19.
Apply anti-squeak tape to the flats of the steering wheel hub casting (Figure 9).
20.
Install the clockspring to the multitunction switch and connect it's wiring connector to the vehicle harness connector.
21.
Install the lower steering column shroud onto the steering column. Install and securely tighten the screw attaching the lower shroud to the column.
22.
Install the upper steering column shroud and securely tighten the two screws attaching the upper to lower shroud.
CAUTION
DO NOT FORCE THE STEERING WHEEL ONTO THE STEERING COLUMN SHAFT. PULL THE STEERING WHEEL DOWN ONTO THE
SHAFT USING THE STEERING WHEEL RETAINING NUT.
Fig. 10
23.
Align the master splines on the steering wheel and the steering column shaft as well as the flats on the steering wheel hub with the formations on
the clockspring and install the wheel onto the shaft. Wiring leads from the clock spring must be routed as shown in Figure 10.
24.
Install the steering wheel damper as shown in Figure 4.
