Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
between the airbag module and the steering wheel.
28.
From the backside of the steering wheel, install the three (3) screws that secure the driver's airbag module to the steering wheel (Figure 1). Tighten
the screws to 100 in-lbs (11 Nm).
29.
With the ignition switch in the ON position, connect the negative battery cable.
30.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then turn it back to the ON position.
31.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures
manual to diagnose and repair the problem.
