Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Knock Sensor: Service and Repair
Fig 12 Knock Sensor
NOTE: The knock sensor threads into the side of the cylinder block in front of the starter (Fig. 12).
REMOVAL
1. Disconnect electrical connector from knock sensor.
2. Use a crow foot socket to remove the knock sensor.
INSTALLATION
1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft lb) torque.
CAUTION: Over or under tightening effects knock sensor performance, possibly causing improper spark control.
2. Attach electrical connector to knock sensor.
