Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
5. Install a screw type hose clamp on the power steering hose to steel tube connection. Tighten the screw clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
fluid pressure and return hoses. This is required to keep the power steering hoses from becoming overheated.
6. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses
to keep them in their proper position.
7. Fill the power steering system with fluid, bleed air from system and check that power steering fluid is at correct level.
