Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
13. If equipped, remove the wheel stop from the steering knuckle. When installing the pinch bolt when assembling the steering knuckle to the ball joint
, the pinch bolt must be installed from the rear facing the front on the vehicle.
14. Remove the steering knuckle to ball joint stud, clamping nut and bolt from the steering knuckle.
15. Using a pry bar, separate steering knuckle from ball joint stud. Note: Use caution when separating ball joint stud from steering knuckle, so ball
joint seal does not get cut.
NOTE: Care must be taken not to separate the inner C/V joint during this operation. Do not allow driveshaft to hang by inner C/V joint after
removing outer C/V Joint from the hub/bearing assembly in steering knuckle, end of driveshaft must be supported.
