Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
a hub/bearing which is corroded to the axle, lightly tap the disc brake caliper adapter using a soft faced hammer. This will remove both the disc
brake caliper adapter and hub/bearing from the axle. The hub/bearing will then need to be removed from the caliper adapter.
Hub/Bearing Removal And Installation
16. Remove the hub/bearing from the axle.
Hub/Bearing Removal From Caliper Adapter
17. If the disc brake caliper adapter and hub/ bearing were removed as an assembly from the axle and the hub/bearing cannot be removed from the
adapter by hand, use the following procedure to remove it from the adapter. With a helper supporting the caliper adapter in his hands, position
Remover, Special Tool 8214-1 or equivalent on the cast housing of hub/bearing. Do not position special tool on inner race of hub/bearing. Lightly
strike Remover, Special Tool 8214-1 or equivalent with a hammer to remove the bearing.
