Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Seal Removal
4. Pry out seal with a pry bar.
INSTALLATION
1. Clean and inspect seal area.
2. Remove input shaft from housing and stand on soft block of wood. Install input shaft end seal with seal installer 5065 and handle C-4171.
3. Lubricate seal lip after installing seal into input shaft.
4. Clean sealing surfaces of the end cover and P.T.U. case. Apply a bead of MOPAR Gasket Maker, Loctite Gasket Eliminator No. 518 or
equivalent.
Bolt Tightening Sequence
5. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 inch lbs.). Retighten first bolt after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
6. Reinstall P.T.U. assembly.
7. Check and fill fluids as required.
