Voyager L4-2.4L VIN B (2001)
a.
Position the new heating element with the lettering facing the front of the seat foam pad (Fig. 1).
b.
Feed the wiring harness through the access hole in the foam pad and the seat cushion pan and install connector to the heated seat module.
c.
Remove the paper backing off the new heating element and press the element onto the foam pad. Align the edges of the heating element with
the edges of the center trench so that the bridges of the element can be fully seated in the center trench (Fig. 1).
8.
For seat trim code CL:
a.
Position the new heating element as shown in (Fig. 2) and teed the wire harness through the access hole in the foam pad and seat cushion
pan and install the connector to the heated seat module.
b.
Remove the paper backing off the new heating element and press the element onto the foam pad.
9.
Place the seat cushion cover in position on the seat cushion.
10.
Engage the J-strap retainers to hold seat cover to cushion.
11.
Place outboard seat side cover in position and connect the power seat wiring connector.
