Voyager L4-2.4L VIN B (2001)
a.
Remove the paper backing off the new heating element and press the element onto the foam pad as shown in (Fig. 3).
b.
Wrap the upper ends of the heating element over the edge of the trench making sure it does not cover the velcro hooks (Fig. 3).
c.
Route the heating element wiring harness as noted in step 9 and attach connector.
11.
Place the seat back cover in position on the seat.
12.
Engage the J-straps and the velcro straps of the seat back cover to the seat back.
13.
Install inboard seat cushion side cover.
14.
Install the seat back panel.
15.
Install the lumbar support lever (if equipped).
16.
Install the seat arm rest.
17.
Position seat into vehicle.
18.
Tip seat rearward and connect seat wiring connectors to body harness.
19.
Position seat and riser to floor.
20.
From underneath the vehicle, install seat attaching nuts and tighten to 60 Nm (44 ft. lbs).
21.
Connect battery negative cable.
Procedure Three - Seat Back With Side Airbags
NOTE:
ON FRONT SEATS EQUIPPED WITH SIDE AIRBAGS, THE SEAT BACK IS SERVICED AS AN ASSEMBLY. REFER TO THE MOPAR
PARTS CATALOG TO ORDER THE COMPLETE SEAT BACK ASSEMBLY BY TRIM AND COLOR CODE.
1.
Remove the headrest.
2.
Remove the armrest.
