Voyager L4-2.4L VIN B (2001)
9. Remove the parking brake cable housing retainer from the brake support plate using a 14 mm wrench try compress the retaining fingers.
INSTALLATION - PARKING BRAKE CABLE (FRONT)
1. Pass front parking brake cable assembly through hole in floor pan from the inside of the vehicle.
2. Pass cable strand button through the hole in the lever (pedal) assembly bracket.
3. Install cable retainer onto the park brake cable and then install cable retainer into pedal assembly bracket.
4. Install the end of the park brake cable into the retainer previously installed into the park brake pedal bracket.
5. Install cable strand button into the clevis on the park brake pedal mechanism.
6. Install the front park brake cable floor pan seal into hole in floor pan. Seal is to be installed so the flange on the seal is flush with the floor pan.
Fold carpeting back down on floor.
7. Raise vehicle.
8. Insert brake cable and housing into body outrigger bracket making certain that housing retainer fingers lock the housing firmly into place.
9. Manually reset the automatic self-adjusting mechanism tension of the parking brake lever (pedal) assembly.
10. Assemble the park brake cables onto the park brake cable equalizer.
11. Lower vehicle and apply the park brake pedal 1 time. This will seat the parking brake cables.
INSTALLATION - PARKING BRAKE CABLE (INTERMEDIATE)
1. Install the ends of the park brake cables through the frame rails and into the side brackets.
2. Install the locking nuts at each end of the cable and securely tighten.
3. If the vehicle is a short-wheel-base model, it will be necessary to reinstall the fuel tank to its normal mounting position.
4. Install the intermediate parking brake cable on the cable connector at the right rear parking brake cable.
5. Install the intermediate park brake cable on the cable equalizer.
6. Remove the locking pliers from the front park brake cable. This will activate the automatic adjuster and correctly adjust the parking brake cables.
7. Install and position the foam collar on the parking brake cable to prevent it from rattling against the vehicle's floor.
8. Lower the vehicle and apply the park brake pedal 1 time, this will seat the park brake cables.
INSTALLATION - PARKING BRAKE CABLE (RIGHT REAR)
1. Install the rear parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable
housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the parking brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body outrigger bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect the right rear parking brake cable to the connector on the intermediate parking brake cable.
6. Install the brake drum, then the wheel and tire assembly.
7. Remove the locking pliers from the front park brake cable. This will automatically adjust the park brake cables.
8. Lower the vehicle.
9. Apply and release park brake pedal 1 time. This will seat the park brake cables.
INSTALLATION - PARKING BRAKE CABLE (LEFT REAR)
1. Install the rear parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable
housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the park brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
