Voyager L4-2.4L VIN B (2001)
Compass: Service and Repair
Compass Calibration
CAUTION: Do not aplace any external magnets, such as magnetic roof mount antennas, in the vicinity of the compass. Do not use magnetic tools when
servicing the overhead console.
The electronic compass unit features a self-calibrating design, which simplifies the calibration procedure. This feature automatically updates the compass
calibration while the vehicle is being driven. This allows the compass unit to compensate for small changes in the residual magnetism that the vehicle
may acquire during normal use. If the compass readings appear to be erratic or out of calibration, perform the following calibration procedure. Also, new
service replacement Electronic Modules (EVIC, CMTC, CT) must have their compass calibrated using this procedure. Do not attempt to calibrate the
compass near large metal objects such as other vehicles, large buildings, or bridges; or, near overhead or underground power lines.
NOTE: Whenever the compass is calibrated manually, the variance number must also be reset. Refer to Compass Variation Adjustment.
Calibrate the compass manually as follows:
1. Turn the ignition switch to the ON position. If the compass/thermometer data is not currently being displayed, momentarily depress and release the
C/T push button to reach the compass/thermometer display.
2. On Electronic Vehicle Information Center (EVIC) and Compass Mini-Trip Computer (CMTC) equipped vehicles depress the Reset push button
and hold the button down until "CAL" appears in the display. This takes about ten seconds, and appears about five seconds after "VAR = XX" is
displayed. On Compass Temperature Module (CT) equipped vehicles depress the C/T push button and US/M push button down until "CAL"
appears in the display. This takes about ten seconds, and appears about five seconds after "VAR = XX" is displayed.
3. Release the push button(s).
4. Drive the vehicle on a level surface, away from large metal objects and power lines, through three or more complete circles at between five and
eight kilometers-per-hour (three and five miles-per-hour) in not less than 48 seconds. The "CAL" message will disappear from the display to
indicate that the compass is now calibrated.
NOTE:
-
If the "CAL" message remains in the display, either there is excessive magnetism near the compass, or the unit is faulty. Repeat the calibration
procedure one more time.
-
If the wrong direction Is still indicated in the compass display, the area selected for calibration may be too close to a strong magnetic field.
Repeat the calibration procedure In another location.
