Voyager L4-2.4L VIN B (2001)
Fuel Injector: Service and Repair
REMOVAL
Fig. 8 Fuel And Injectors
The fuel rail must be removed first (Fig. 8).
1. Disconnect injector wiring connector from injector.
Fig. 9 Fuel Injector And Rail Typical
2. Position fuel rail assembly so that the fuel injectors are easily accessible (Fig. 9).
3. Rotate injector and pull injector out of fuel rail. The clip will stay on the injector.
4. Check injector O-ring for damage. If O-ring is damaged, it must be replaced. If injector is reused, a protective cap must be installed on the injector
tip to prevent damage. Replace the injector clip if it is damaged.
5. Repeat for remaining injectors.
INSTALLATION
The fuel rail must be removed first.
1. Before installing an injector the rubber O-ring must be lubricated with a drop of clean engine oil to aid in installation.
2. Install injector clip by sliding open end into the top slot of the injector. The edge of the receiver cup will slide into the side slots of clip.