Voyager L4-2.4L VIN B (2001)
The BCM has 1 Liftgate switch input located in the overhead console
-
Power Lockout Switch Input
The BCM has 1 Lockout switch that when enabled will disable the B-Pillar sliding door switches from activating either sliding door when
depressed. When replacing a body control Module there are 2 modules available, a Base and a Midline. The Midline controller is used on vehicles
that have Power Door Locks. If a vehicle is equipped with the Vehicle Theft Security System, the midline controller becomes a premium when the
theft feature is enabled.
NOTE: DO NOT SWAP THE BODY CONTROL MODULE BETWEEN VEHICLES OR BODY CONTROL MODULES OFF THE SHELF.
Engineering does not recommend that service, dealers or the plant swap Body Control Modules (BCM) between vehicles or off the shelf. The
BCM has internal diagnostic capability that assists in diagnosing the system. When an "Open" or a "Short" circuit exists, the diagnostic tool can be
used to read the BCM codes. The codes are very descriptive in identifying the appropriate feature that has faulted.
CHIME WARNING SYSTEM
The BCM monitors the door liftgate ajar switches, multifunction switches, headlight switch, ignition switch, PCI bus, and the diagnostic tool to
perform various chime operations. The BCM uses a low-side driver to control the chime located in the cluster.
The chime system provides the Driver with warning chimes for:
-
Seat belt
-
Exterior lights ON
-
Key-in Ignition
-
Key-in Accessory
-
Engine temperature critical
-
Low washer fluid
-
Turn signals ON
-
Dome light ON
-
Low oil pressure
-
Any warning lamp announcement
-
High-speed warning (GCC)
The output sound intensity of the chime is approximately 72 decibels.
Chime Priority
The following list indicates the priority of the chime when more than one chime is active at the same time:
-
Seat belt warning
-
High-speed warning (GCC)
-
Turn signal ON
-
Chime request
-
Warning lamp announcement
The cluster is responsible to set priority on all warning lamp announcement chimes.
Chime ON Conditions
The following is a list of the chime warnings and when they will sound.
Driver's Seat belt Unbuckled:
Sounds for approximately 6 ± 2 seconds when the ignition is turned ON and driver's seat belt is not buckled, as a reminder to the driver to
buckle the seat belt.
Exterior Lights ON:
Ignition is in the lock position, the driver door is ajar, and the headlight switch is left in any position, other than auto or OFF. The chime will
sound as a warning to the driver until one of the above conditions is removed or until the battery protection time of 3 minutes has expired.
Key-In Ignition:
Ignition is in the lock position, driver door is ajar and the key is in the ignition. The chime will sound until one of the above conditions is
removed or until the battery protection time of 15 minutes has expired.
Turn Signal ON:
When the BCM detects a turn signal input continuously for 1.0 mile/ 0.6km and the vehicle speed is greater than 15 mph/24kph, the chime
will sound until the specific turn signal is cancelled.
Dome Lights ON:
Ignition is in the lock position, driver doorajar, and the dome light switch is left in the ON position. The chime will sound until one of the
above conditions is removed or until the battery protection time of 15 minutes has expired.
