Voyager L4-2.4L VIN B (2001)
14. Remove the 3 bolts and nuts mounting the steering gear to the front suspension cradle.
NOTE: The next step must be done to allow the removal of the steering gear from the front suspension cradle. The steering gear can not be
removed from the vehicle with the intermediate coupler attached to the steering gear.
15. Lower steering gear from suspension cradle enough to allow access to the intermediate coupler roll pin. Install Remover/Installer Special Tool
6831A through the center of the roll pin, securing with the knurled nut. Hold threaded rod stationary while turning nut, this will pull the roll pin
out of the intermediate coupler.
16. Separate the intermediate coupler from the shaft of the steering gear.
17. Remove the steering gear assembly from the vehicle.
INSTALLATION
1. Install the steering gear up in the front suspension cradle, leaving room to install intermediate coupler.
2. Start the roll pin into the intermediate coupler before installing coupler on steering gear shaft. Start roll pin into coupler, using a hammer and
tapping it into the coupler. Then install the intermediate coupler on the shaft of the steering gear.
