Voyager L4-2.4L VIN B (2001)
2. Align strut assembly with steering knuckle. Position arm of steering knuckle into strut assembly clevis bracket. Align the strut assembly clevis
bracket mounting holes with the steering knuckle mounting holes. Install the 2 strut assembly to steering knuckle attaching bolts. If strut assembly
is attached to steering knuckle using a cam bolt, the cam bolt must be installed in the lower slotted hole on strut clevis bracket. Tighten the strut
clevis-to-steering knuckle attaching bolts to a torque of 81 Nm (60 ft. lbs.) plus an additional 1/4 (90°) turn after specified torque is met.
3. Install the stabilizer bar link mounting stud through the bracket on the strut assembly.
CAUTION: When installing the nut on the mounting stud of the stabilizer bar link, do not allow the stud to rotate in it's socket. Hold the stud from
rotating by placing an open-end wrench on the flat machined into the stud.
4. Hand thread the nut on the end of the stabilizer bar link stud. Hold the stud from turning by placing an open-end wrench on the flat machined into
the link's mounting stud, then tighten the nut while holding the wrench in place. Tighten the nut to a torque of 88 Nm (65 ft. lbs.).
