Voyager L4-2.4L VIN B (2001)
9. Install the strut through the bottom of the coil spring until the lower spring seat contacts the lower end of the coil spring. The clevis bracket on the
strut should point straight outward away from the compressor (to the 6 o'clock position). This position should be within 5° of the lower end tip of
the coil spring. If necessary, reposition the strut or coil spring in the compressor so both of these line up straight outward away from the
compressor (to the 6 o'clock position). Install the clamp to hold the strut and coil together.
10. Install the strut mount over the strut shaft and onto the top of the pivot bearing and upper seat as shown. Loosely install the retaining nut on the
strut shaft.