Voyager L4-2.4L VIN B (2001)
5. Reinstall gears to pump body and measure outer gear-to-pocket clearance with a feeler gauge (Fig. 184). Outer gear-to-pocket clearance should be
within 0.046 - 0.141 mm (0.0018 - 0.0056 inch).
6. Measure both inner and outer gear side clearance with Plastigage(TM). If Plastigage(TM) is not available, measure across the pump body with a
straight edge and feeler gauge.
a. Position an appropriate piece of Plastigage(TM) across both gears.
b. Align the plastigage to a flat area on the reaction shaft housing.
c. Install the reaction shaft support to the pump housing and torque to 28 Nm (250 inch lbs.).
d. Separate the reaction shaft housing from the pump housing and measure the Plastigage (TM) following the instructions supplied with it. Inner
and outer gear side clearance should be within 0.020 - 0.046 mm (0.0008 - 0.0018 inch).
Assembly
ASSEMBLY
1. Install inner and outer gears to pump body (Fig. 183). Lubricate gears.
2. Install reaction shaft support to pump body and align holes.
