Voyager V6-3.0L VIN 3 (2000)
Fig. 1
2.
Disconnect the electrical connector from the ignition coil module, Figure 1.
3.
Remove the ignition coil module bottom-forward mounting bolt and discard.
Fig. 2
4.
Attach the supplied capacitor to the ignition coil module with the supplied bolt, Figure 2. Torque the screw to 10-15 Nm (85-125 in. lbs.)
5.
Connect the single wire connector of the jumper harness to the suppression capacitor. Then connect the jumper harness between the ignition coil
module and the powertrain harness connector, Figure 2.